- Automation & ControlView all 2,489 products
- Automation Accessories
- AC Drives
- PLC & I/O Cards
- Industrial Communications
- Vibration Monitoring
- Controllers & Data Acquisition
- Isolator & Barrier
- CCTV & Security
- Encoders
- Motor Soft Starters
- Safety Switches & Guard Locking
- HMI Displays
- Pneumatic Cylinders
- Servo Drives
- Industrial Computers
- Machine Vision
- Automation Software
- Robotics
Brand: Extech
Extech SL130W Sound Level Alert with Alarm Output
Description
Extech SL130W sound level alert with alarm output
The Extech SL130W is a wall, desk or tripod-mounted sound level monitor that watches noise continuously and shows the result on large red and green LEDs readable from up to 30 m (100 ft) away. The user sets a high or low limit anywhere from 30 to 130 dB; when the limit is crossed the LEDs flash, and a 3.5 mm output can drive an external relay module for a siren, light or logging system. The microphone rotates through 180 degrees and can be moved away from the display with an optional 5 m extension cable.
The datasheet states that the SL130W meets ANSI Type 2 and EN 60651 accuracy specifications. A 4.6 x 3.125 in multifunction LCD shows the level, with programmable A or C weighting and fast (125 ms) or slow (1 s) response.
Technical specifications of the SL130W
| Parameter | Specification |
|---|---|
| Manufacturer / part number | Extech / SL130W (optional SL125 remote microphone cable, 5 m) |
| Measurement ranges | 30 to 80 dB, 60 to 110 dB, 80 to 130 dB; 0.1 dB resolution |
| Alarm limit | User-settable high or low limit, 30 to 130 dB |
| Frequency bandwidth | 31.5 Hz to 8 kHz |
| Weighting / response | A and C programmable; fast 125 ms / slow 1 s |
| Microphone | 0.5 in electret condenser microphone, rotates 180 degrees; remote use with extension cable |
| Display | 4.6 x 3.125 in multifunction LCD plus red and green alert LEDs |
| Alarm output | 3.5 mm mono phone plug, maximum 3.4 mA at 5 V DC; minimum output voltage 2.5 V DC |
| Power | AC/DC adaptor (100-240 V AC, 50/60 Hz) for full functions; 8 x AA for monitoring only without LED alert |
| Mounting | Built-in wall, desk and tripod mount (optional tripod TR100) |
| Weight | Approx. 285 g |
The figures above are from the SL130W datasheet.
High and low limit modes of the SL130W
The SL130W works in two ways. In the high-limit mode, the LEDs are green while the level is acceptable and flash red when the noise exceeds the limit, which suits a workshop, a classroom or a hospital ward where the level must not go too high. In the low-limit mode, the LEDs flash red when the sound falls below the set point, which is useful for auditoriums and training rooms where speech must stay audible to the audience. The user can also swap the red and green colours to suit local preference.
The alarm output turns the sound level into a switching signal. Connected to a relay module, it can start an extraction fan, sound a warning, or inform a building management system, and the LED display can be seen across a large hall, so people see the warning without looking at the meter.
Where the SL130W fits
- Industrial areas: warning lights at the entrance to a high-noise zone, based on the set level.
- Hospitals and classrooms: visual feedback when the noise passes a quiet-zone limit.
- Auditoriums and theatres: low-limit alert when speech or music is too quiet.
- Test rooms and laboratories: a continuous display with relay output for logging.
For handheld surveys, the Extech 407730 sound level meter is more convenient; the SL130W is for continuous monitoring in a fixed location.
Selection checklist for the SL130W
- Confirm that the limits you require fall between 30 and 130 dB.
- Decide whether the microphone must be remote from the display, in which case order the SL125 extension cable.
- Check that mains power is available, since the LED alert needs the AC/DC adaptor.
- Decide on A or C weighting and fast or slow response for the area.
- Plan for a tripod (TR100) if the location has no wall or desk.
Installation and care of the SL130W
Mount the SL130W at ear height in the area of interest, away from walls and reflecting surfaces, and point the microphone at the dominant noise source. For reliable alerting use the AC/DC adaptor, since battery operation gives measurement only without the LED alert. Fit the windscreen outdoors, keep the microphone clean and dry, and check the reading against an acoustic calibrator at regular intervals. Wire the alarm output to the relay module using a shielded cable and keep the load within the output limit of 3.4 mA.
Applications of the SL130W in Oman and the GCC
Industrial plants, hospitals, schools and conference venues across Oman and the GCC set noise limits that need continuous supervision rather than occasional spot checks. A large LED display, visible from 100 ft, works in busy plant areas where a handheld meter would not be noticed. Indoor air-conditioned spaces are preferred; for outdoor monitoring in the heat, keep the unit shaded and use a weather-protected enclosure.
Practical set-up tips
Set the limit just below the level where action is needed, so the alert warns before a breach rather than after. Use the slow response for general monitoring so that the display does not flicker with every short peak, and use the fast response when impulsive noise is the concern. After installation, check the alert with a known loud source and record the result in the commissioning sheet. Review the limit settings when the use of the room changes.
Information to send with an RFQ for the SL130W
- Part number SL130W and the required quantity
- Limit levels and whether high or low limit mode is needed
- Whether the SL125 extension cable, tripod or relay module is needed
- Delivery location in Oman or the GCC and the required lead time
- Whether calibration documentation or a traceable calibration certificate is required
Documents and quotation
A datasheet for the Extech SL130W is attached on this page. It lists the ranges, limit settings and alarm output.
Send us the part number SL130W, the quantity and the delivery location in Oman or the GCC, and we will reply with availability and a quotation. Seven Star LLC is an independent supplier in Muscat and is not affiliated with the manufacturer.
Other Models in the Extech Sound Level Range
Seven Star LLC supplies models from the Extech Sound Level range in Oman and the GCC. Compare the related models below and request a quote for the one that matches your application.
| Model | Category | |
|---|---|---|
| Extech 407730 Digital Sound Level Meter, 40 to 130 dB | Air Flow, IAQ & Sound Meters | View details |
| Extech SL130W Sound Level Alert with Alarm Output | Air Flow, IAQ & Sound Meters | You are viewing this model |
Datasheets & Documents
- Datasheet Extech SL130W Datasheet Download
Reviews (0)
How would you rate this product? Cancel reply
About brand
Extech Instruments is an American brand of handheld test and measurement instruments, founded in the early 1970s in Waltham, Massachusetts. FLIR Systems acquired Extech in 2007 for about $40 million, and FLIR itself became part of Teledyne in 2021. Extech is based in Nashua, New Hampshire, and makes meters for electrical, environmental and HVAC testing.
Extech company profile
| Founded | Early 1970s, Waltham, Massachusetts |
|---|---|
| Headquarters | Nashua, New Hampshire (since 2011) |
| Ownership | Teledyne FLIR |
| Acquired by FLIR | 2007 |
| Product families | True RMS clamp meters and multimeters, insulation testers, power analysers, IR thermometers, light meters, vibration meters, sound, humidity and air quality meters |
Milestones
- 2007: FLIR Systems acquires Extech.
- 2011: Extech moves to Nashua.
- 2021: FLIR becomes part of Teledyne.
Meters, testers and inspection tools
The Extech range includes multimeters and clamp meters, insulation and resistance testers, power analyzers, thermometers, light and sound level meters, anemometers, tachometers, vibration meters, moisture meters, borescopes and water quality meters. Each datasheet and user manual lists ranges, accuracy, safety category and ordering codes, and many models are listed with NIST-traceable calibration versions ordered by adding -NIST to the part number.
Supply through Seven Star LLC
Seven Star LLC is an independent supplier in Muscat that quotes Extech products for projects in Oman and the GCC, with the official Extech datasheet and user manual attached to each product page.
Extech products we list
Facts checked against FLIR's 2007 announcement and published Extech histories, October 2026.
FAQ
Questions about the Extech SL130W Sound Level Alert with Alarm Output
Answers from our engineering team on installation, compatibility and integration.
01What does the Extech SL130W do?
The SL130W continuously monitors sound level and shows red or green LEDs, visible from about 30 m, with a user-set high or low limit between 30 and 130 dB.
02Can the SL130W drive an external alarm?
Yes. A 3.5 mm mono output, 3.4 mA maximum at 5 V DC, can drive an external relay module for sirens, lights or building systems.
03What measuring ranges does the SL130W have?
It has three ranges, 30 to 80 dB, 60 to 110 dB and 80 to 130 dB, each with 0.1 dB resolution.
04How is the SL130W powered?
The AC/DC adaptor gives full function; eight AA batteries run the measurement only, without the LED alert.
05Can the microphone of the SL130W be remote?
Yes. The microphone rotates 180 degrees and can be used remotely with the optional SL125 5 m extension cable.


















Reviews
There are no reviews yet.